Bodyguard T270 Manuel d'instructions télécharger pdf (Page 53)

TREADMILLS – OWNER’S MANUAL

pulley and the front roller puller may be loose / Remove the motor

cover and see if the drive belt physically stops at the same time as

the running belt stops. If so, tighten drive belt by tightening motor

plate screws which will pull the motor pulley away from the front

roller pulley causing the drive belt to tighten. Contact your

Bodyguard Dealer for assistance.

• Unable to exit at the end of a program.

• Incline is not calibrated / Perform Incline Calibration

• An Error code is displayed on screen.

• See Table 4 below

6.6. ERROR CODES

Table 4 – Error Codes

PROBLEM

POSSIBLE CAUSE / SOLUTION

• Error 51

• There is a communication problem between the display console and the motor drive

board

• Possible causes: Bad connection of the cable between the display console and the motor

drive board or potential problem with the motor drive board or the computer.

• Error 52

• Problem on the motor drive board.

• Possible cause: Defective motor drive board / Contact your Bodyguard Dealer.

• Possible cause: The main motor wires are not well connected to the motor drive board /

Check wires connections to the motor drive board in this case.

• Error 53

• “No speed signal” error. No speed reading from speed sensor for 5 seconds continuously

or speed sensor reading is far below set speed.

• Possible cause: Belt somehow stuck, or sensor defective or not connected.

• Error 54

• Main relay problem on motor drive

• Possible cause: Defective motor drive board / Contact your Bodyguard Dealer.

• Error 55

• Hardware maximum current limit exceeded on motor drive board (maximum is 31 amp

peak DC instantaneously)

• Possible cause: Drive board defective, defective motor drive board or too much friction

between the deck and running belt.

• Error 56

• Speed error. Speed reading of 50% lower or 150% higher than set speed. So if set at 5

mph, this error will be displayed if speed reading is less than 2.5 mph or more than 7.5

mph

• Possible cause: Defective drive board, speed sensor problem or speed sensor cable

problem.

• « ! » on-screen

symbol (T240S-

T280S-T520S:

Error D6-1)

• First threshold of maintenance has been reached or exceeded.

• Possible cause: The friction between the deck surface and the running belt is too high /

You need to service the deck either by applying lubricant or by flipping the deck if the

surface is worn out. The treadmill will allow you to restart even if the maintenance has

not been done and the maintenance counter has not been reset but it is a good practice

to service the treadmill when the first threshold is reached and not wait for the second

threshold of maintenance to appear on screen.

• « X » on-screen

symbol (T240S-

T280S-T520S:

Error D6-2)

• Second and last threshold of maintenance has been reached or exceed / You need to

service the deck by applying lubricant or by flipping the deck if the surface is worn out.

The treadmill will not restart until the maintenance has been done and the maintenance

counter has been reset.

1 2 ... 48 49 50 51 52 53 54 55 56

Commentaires sur ces manuels

Pas de commentaire

Bodyguard T270 Manuel d'instructions Page 53

Commentaires sur ces manuels

Produits connexes et manuels pour Tapis de course Bodyguard T270