Bodyguard T700 Manuel du propriétaire télécharger pdf (Page 31)

Belt and Running Deck

Running Belt

The running belt supplied with each treadmill is of the highest

quality, offering superior traction and low noise under extreme

conditions. It is therefore important to maintain each running

belt periodically by observing that no cuts have appeared over

time, and that the running belt has not shifted to one side of

the deck surface. If the running belt constantly tracks (or moves)

to one side of the deck, you must adjust the alignment bolts

placed at the rear of the running belt.

See Belt Alignment for complete procedure.

Deck Surface

The running deck needs to remain free of any loose items that

may become trapped between the running belt and the rollers.

Avoid dropping liquids on the deck as this may cause gum up

problem on the belt.

Under extreme conditions resulting in heavy wear and tear on

the deck surface, it may be necessary to remove the deck and

turn it over, or turn it back-to-front to expose a fresh surface.

The deck is especially designed to offer four reversible sides for a

longer life use of the deck.

Please contact your Bodyguard

Dealer for servicing the deck.

Make certain to have the power off before doing any

maintenance.

1 - Breaker

2 - ON/OFF switch

Drive motor with connection wires.

1 - Speed sensor cable

2 - Computer power cable

3 - Elevation sensor cable

4 - Elevation motor cable

5 - Power AC cable

6 - Motor cable

Lubricant Application

1. Clean the deck surface and the inside part of the belt with a dry piece of fabric.

Clean the belt ﬁrst by using a long piece of fabric across the belt and start the

belt so it makes two co mplete turns. Then, release the tension on the rear roller

to be able to clean the deck surface of any debris or remaining wax.

2. Open the lubricant supplied by your dealer. Place the lubricant tube in the middle

of the belt at about 15 inches from the hood cover. Step on the treadmill and

step down with your feet where the lubricant tube is located under the belt to

make sure that most of the lubricant is now spread evenly on the deck surface.

DO NOT START THE TREADMILL YET.

3. Remove the LUBE TUBE from under the belt and put the tension back again on

the rear roller. Stand where you applied the lubricant and press JustGo

/ENTER

key to start the belt turning at 0.5 mph (or 0.8 km/h). Let the belt bring you a the

back of the treadmill and come back where you were standing. Do this twice so

the lubricant will be present on the total surface of the deck. Start the treadmill

and make sure the belt alignment is correct. Refer to the owner’s manual if any

problem occurs.

ﬁgure 10

ﬁgure 11ﬁgure 11

Motor in treadmill 240 VLT

Motor in treadmill 120 VLT

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Commentaires sur ces manuels

Pas de commentaire

Bodyguard T700 Manuel du propriétaire Page 31

Commentaires sur ces manuels

Produits connexes et manuels pour Tapis de course Bodyguard T700