Bodyguard T700 Manuel du propriétaire télécharger pdf (Page 25)

Possible Contact Heart Rate Problems

In order to properly diagnose any problem with the conctact heart rate system, please refer to the following procedures.

This machine uses a hand ECG (Electrocardiogram) printed circuit board along with wires and a set of metal plates. The hand

ECG board is an integral part of the machine and is hidden inside.

Troubleshooting Check List – Table 2

Access to “Diagnostics” menu

To determine the condition of the various electrical and mechanical components, you will need to enter into the

DIAGNOSTICS menu as follows:

1. Turn power OFF.

2. Simultaneously hold down the speed INCREASE and DECREASE keys and turn power ON.

3. Release the speed INCREASE and DECREASE keys once entered into the Diagnostics menu.

4. Press JustGo

/ENTER to access Diagnostic items.

When you access the Diagnostics menu, you will notice the following message: “TXXX VERSION”

The message above indicates the version of the computer software installed in your computer display monitor. This

information is helpful in diagnosing certain computer related conditions. Keep in mind that the version number may

change depending on the model number of your T700 treadmill.

The T700 treadmill allows you to perform the following tests :

To perform any one of the above procedures, press the Speed INCREASE or DECREASE keys to select the one you

want and press the JustGo

/ENTER key to accept.

• NVRAM TEST

• EPROM TEST

• KEYPAD TEST

• DISPLAY TEST

• SOUND TEST

• HEART RATE TEST

• BELT ALIGNMENT

• MOTOR CHECK

• ELEVATION CALIBRATION

• STATISTICS

• ERROR LOG

• CURRENT TEST

• SPEED SENSOR TEST

• MAINTENANCE

CCoommppuutteerr DDiiaaggnnoossttiiccss

Computer Diagnostics

PROBLEM

• No reading

• Erratic reading

POSSIBLE CAUSE

• Hands have not been in contact

with the metal plates long enough

• Defective hand contact board

• Wires are not connected properly

• Hands may move too much on the plates

• Defective board hand contact board

• Strong neon lights too close to console

• Interference with other signals

SOLUTION

• Wait for 15-20 seconds before

a reading

• Change ECG board

• Verify Wiring

• Do not move your hands

• Change board

• Move the climber

• Use only this machine to verify

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Bodyguard T700 Manuel du propriétaire Page 25

Commentaires sur ces manuels

Produits connexes et manuels pour Tapis de course Bodyguard T700